Cisco ASA5500-HW - Hardware Accessory Kit Network Device Guia de Instalação descarregar pdf (Página 69)

B-7

Cisco ASA 5500 Series Hardware Installation Guide

OL-10089-01

Appendix B Maintenance and Upgrade Procedures

Removing and Replacing the Power Supply

Replacing the AC Power Supply

To replace the AC power supply, perform the following steps:

Step 1 Insert the new power supply into place and slide it towards the back of the adaptive security appliance.

Step 2 Lift the rear of the adaptive security appliance from the surface and reinstall both screws.

Step 3 Insert the power supply brace and press down until it fits into place, as shown in Figure B-8.

Figure B-8 Replacing the Power Supply Brace and the AC Power Supply

Step 4 Connect the power connector to the system board.

Step 5 Replace the adaptive security appliance cover. See “Replacing the Chassis Cover” for more information.

Step 6 Reinstall the network interface cables.

1 Back panel 3 Power supply brace

2 Power supply 4 Front panel

119579

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 81 82

Sem comentários

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Guia de Instalação Página 69