Cisco OL-6109-01 Manual do Utilizador descarregar pdf (Página 4)

Chapter 4 Zone Configuration

Basic Zone Configuration

4-4

Cisco Traffic Anomaly Detector User Guide

OL-6109-01

2. Choose ENTER. The following prompt appears:

admin@DETECTOR–conf-zone-<new-zone-name>#

To duplicate a zone from the zone command group level perform the following:

1. From the Zone command group level of the desired zone type the following:

admin@DETECTOR–conf-zone-<zone-name># zone <new-zone-name>

copy-from–this

Where new-zone-name specifies a zone name string. An alphanumeric string

should start with a letter, hold no spaces, and should be limited to a length of

up to 63 characters. The string may contain underscores.

2. Choose ENTER. Below is an example of the zone command implementation:

admin@DETECTOR-conf-zone-scannet# zone mailserver copy-from-this

admin@DETECTOR-conf-zone-mailserver#

Removing a Zone

The user may remove a desired zone.

Caution Removing a zone eliminates its DDoS detection.

To remove a desired zone perform the following:

1. From the Configuration command group level type the following:

admin@DETECTOR-conf# no zone <zone-name>

Where zone-name identifies the zone name. Use ‘*’ to remove all zones.

2. Choose ENTER.

Note The Detector allows inserting an asterisk (*) as a wildcard character at the end of

a zone name. Thus, a user may use the wildcard character (*) to remove several

zones with the same prefix in one command.

1 2 3 4 5 6 7 8 9 ... 21 22

Sem comentários

Cisco OL-6109-01 Manual do Utilizador Página 4