Configure ISDN BRI Voice Ports
MOD-4
Release 12.0(4) T
Verify
•
To display protocol information about the ISDN D channel(s), use the
show interfaces bri [number] command.
The following is sample output from the show interfaces bri [number] command for a BRI voice
port on the Cisco MC3810:
router# show interfaces bri 1
BRI1 is up (spoofing), line protocol is up (spoofing)
Hardware is BVM
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, loopback not set
Last input 1w0d, output 1w0d, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
70 packets input, 278 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
70 packets output, 278 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
2 carrier transitions
• To display information about the physical attributes of the ISDN D channel(s), use the
show controllers bri [number] command.
8 network-clock-priority {low | high} If this BRI voice port is configured as TE, and you want it to
be the first-priority BRI voice port for recovering clock from
the network NT device, enter high.
If this BRI voice port is configured as TE, and you want it to
be a lower-priority BRI voice port for recovering clock from
the network NT device, enter low.
This command is not used if this port was configured as NT
in Step 6 with the command isdn layer1-emulate network.
9 isdn overlap-receiving Activate overlap signaling to the destination PBX.
10 isdn network-failure-cause cause code Specify the cause code to pass to the PINX (PBX) when a
call cannot be placed or completed because of internal
network failures. Possible values are from 1 to 127.
11 isdn sending-complete (Optional) Configure the BRI voice port to include the
Sending Complete information element in the outgoing call
setup message. This command is used in some geographic
locations, such as Hong Kong and Taiwan, where the
sending complete information element is required in the
outgoing call setup message.
12 Exit from interface configuration mode and repeat Steps 3 through 11 for each remaining BRI voice port.
Step Command Purpose
(378 páginas)
(298 páginas)
(2 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais