Cisco 1710 Especificações descarregar pdf (Página 59)

4-3

Cisco 1710 Security Router Software Configuration Guide

78-12696-01

Chapter 4 Configuring Routing Between VLANs with IEEE 802.1Q Encapsulation

IEEE 802.1Q Encapsulation Configuration Task List

Configuring AppleTalk on the Subinterface

After you enable AppleTalk globally and define the encapsulation format, you

need to enable it on the subinterface by specifying the cable range and naming the

AppleTalk zone for each interface. To enable the AppleTalk protocol on the

subinterface, use the following commands in interface configuration mode:

Defining the VLAN Encapsulation Format

To define the VLAN encapsulation format as IEEE 802.1Q, use the following

commands in interface configuration mode:

Configuring IP Routing over IEEE 802.1Q

IP routing over IEEE 802.1Q extends IP routing capabilities to include support for

routing IP frame types in VLAN configurations using the IEEE 802.1Q

encapsulation.

Command Purpose

Step 1

appletalk cable-range cable-range [network.node]

Assigns the AppleTalk cable range

and zone for the subinterface.

Step 2

appletalk zone zone-name

Assigns the AppleTalk zone for the

subinterface.

Command Purpose

Step 1

interface fastethernet port.subinterface-number

Specifies the subinterface that the

VLAN will use.

Step 2

encapsulation dot1q vlan-identifier

Defines the encapsulation format as

IEEE 802.1Q (dot1q) and specifies

the VLAN identifier.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 87 88

Sem comentários

Cisco 1710 Especificações Página 59