Cisco 1750 - 1750 Router Manual do Utilizador descarregar pdf (Página 10)

Voice Software Enhancements for the Cisco 1750 and Cisco 1751 Routers

OL-1671-01

Supported Features

Connection Mode is normal

Connection Number is not set

Initial Time Out is set to 10 s

Interdigit Time Out is set to 10 s

Call Disconnect Time Out is set to 60 s

Ringing Time Out is set to 180 s

Wait Release Time Out is set to 30 s

Companding Type is u-law

Region Tone is set for US

Analog Info Follows:

Currently processing none

Maintenance Mode Set to None (not in mtc mode)

Number of signaling protocol errors are 0

Impedance is set to 600r Ohm

Station name None, Station number None

Voice card specific Info Follows:

Signal Type is wink-start

Dial Type is dtmf

In Seizure is inactive

Out Seizure is inactive

Digit Duration Timing is set to 100 ms

InterDigit Duration Timing is set to 100 ms

Pulse Rate Timing is set to 10 pulses/second

InterDigit Pulse Duration Timing is set to 750 ms

Clear Wait Duration Timing is set to 400 ms

Wink Wait Duration Timing is set to 200 ms

Wait Wink Duration Timing is set to 550 ms

Wink Duration Timing is set to 200 ms

Delay Start Timing is set to 300 ms

Delay Duration Timing is set to 2000 ms

Dial Pulse Min. Delay is set to 140 ms

Percent Break of Pulse is 60 percent

Auto Cut-through is disabled

Dialout Delay for immediate start is 300 ms

FXS Mode

Enter the following voice-port command to enable FXS mode:

router-config# voice-port 0/0

Router(config-voiceport)# no signal did

Enter the show voice port command to verify that the DID card is in FXS mode:

did_1751a# show voice port 0/0

Foreign Exchange Station with DID (DID-FXS): 0/0 Slot is 0, Sub-unit is 0, Port is 0

Type of VoicePort is FXS VIC-2DID

Operation State is DORMANT

Administrative State is UP

The Last Interface Down Failure Cause is Administrative Shutdown

Description is not set

Noise Regeneration is enabled

Non Linear Processing is enabled

Non Linear Mute is disabled

Non Linear Threshold is -21 dB

Music On Hold Threshold is Set to -38 dBm

In Gain is Set to 0 dB

Out Attenuation is Set to 3 dB

Echo Cancellation is enabled

Echo Cancellation NLP mute is disabled

Echo Cancellation NLP threshold is -21 dB

Echo Cancel Coverage is set to 8 ms

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comentários a estes Manuais

Sem comentários

Cisco 1750 - 1750 Router Manual do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco 1750 - 1750 Router