Cisco 2513 Especificações descarregar pdf (Página 48)

3-16 Router Installation and Configuration Guide

Connecting to a Network

Step 3 If you will be using AutoInstall to conﬁgure the router, connect the synchronous

serial port (DB-60) to a CSU/DSU or other DCE device, as shown in

Figure 3-13. If you do not plan to use AutoInstall (or you are not sure what

AutoInstall is) do not connect the WAN cable until after you have conﬁgured the

router.

If a WAN cable is connected when you power ON the router for the ﬁrst time, it

will attempt to run AutoInstall to download a conﬁguration ﬁle from a TFTP

server. It can take several minutes for the router to determine that the necessary

ﬁles are not in place for AutoInstall to begin. For more information about

AutoInstall, refer to the Cisco IOS conﬁguration guide, which is available on the

documentation CD that accompanied your router.

Note The synchronous serial port supports the following signaling standards:

EIA/TIA-232, EIA/TIA-449, V.35, X.21, and EIA-530.

Figure 3-13 Connecting a CSU/DSU or Other DCE Device

H6569

TOKEN RING

Router

Serial transition

cable

Synchronous serial

port (DB-60)

CSU/DSU or

other DCE

EIA/TIA-232, EIA/TIA-449, V.35,

X.21, or EIA-530 connector

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 137 138

Sem comentários

Cisco 2513 Especificações Página 48