Cisco DPC2203C2 Guia do Utilizador descarregar pdf (Página 39)

4015257 Rev B 39

How Do I Install the Modem for Telephone Service?

3 Connect the active RF coaxial cable to the CABLE connector on the back of the

cable modem. The cable modem begins an automatic search to locate and sign on

to the network that provides the telephone service. This process may take up to 5

minutes. The modem will be ready for use when the ONLINE LED status

indicator on the front panel stops blinking and illuminates continuously

Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top

converter, or a VCR.

4 Test your telephone service by lifting the receiver of each attached telephone to

verify that the dial tone can be heard and that you can make and receive

telephone calls. This process may take several minutes.

Notes:

 The TEL 1 and TEL 2 LED status indicators on the front panel of the cable

modem illuminate when telephony service is enabled.

 The TEL 1 or the TEL 2 LED status indicators on the front panel of the cable

modem blink when the attached device is “off the hook.”

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 51 52

Sem comentários

Cisco DPC2203C2 Guia do Utilizador Página 39