Cisco WET54G Guia do Utilizador descarregar pdf (Página 12)

Chapter 3: Getting to Know the Wireless-G Ethernet Bridge

The Back Panel

Wireless-G Ethernet Bridge

Chapter 3: Getting to Know the Wireless-G Ethernet Bridge

The Back Panel

All connections to the Bridge are made through the ports on its back panel, shown in Figure 3-1.

Reset When pressed, the Reset button resets the Bridge to its factory default settings.

LAN The LAN port is where you will connect the Ethernet network cable.

Power The Power port is where you will connect the power adapter.

Important: If you reset the Wireless-G Ethernet Bridge, you will

erase all of your settings (WEP encryption, wireless settings,

etc.) and replace them with the factory defaults. Do not reset the

Wireless-G Ethernet Bridge if you want to retain these settings.

Figure 3-1: Back Panel

NOTE: If you use a Power over Ethernet (PoE) device to supply

data and power through the Ethernet network cable, then you

do not need to use the Power port.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

Sem comentários

Cisco WET54G Guia do Utilizador Página 12