Cisco IAD2431-1T1E1 Guia de Instalação descarregar pdf (Página 9)

Chassis Installation Options

You can set the chassis on a desktop, install it in a rack, or mount it on a wall.

Tip Before proceeding, consider the location of the equipment with respect to a good ground. See the “Grounding the

Chassis” section on page 13.

See the following instructions:

• Using the Correct Bracket Screws, page 9

• Using Quick Installation Brackets, page 9

• Rack-Mounting the Chassis, page 10

• Wall-Mounting the Chassis, page 11

• Grounding the Chassis, page 13

Caution Use only the mounting hardware supplied with this product.

Using the Correct Bracket Screws

Two sets of bracket attachment screws are provided, in separate packages. Take care to use each screw type, and washers as

needed, in the appropriate locations. Table 1 summarizes the bracket attachment screw types.

Using Quick Installation Brackets

A new bracket accompanies this product. See Figure 4. This bracket, with a keyhole feature, facilitates wall-mounting by

allowing the installer to rest the bracket on a starter screw, freeing the installer’s hands.

• To rack-mount the unit, you have three positioning options. See the “Rack-Mounting the Chassis” section on page 10.

• To wall-mount the unit, attach the short leg of the bracket to the chassis at the pair of holes in the center of the chassis side.

See the “Wall-Mounting the Chassis” section on page 11.

Figure 4 Quick Installation Bracket

Table 1 Bracket Attachment Screws for Rack-Mounting and Wall-Mounting

Rack-mounting Wall-mounting

• Eight Phillips head screws (four per bracket) • Four 6-32 slotted hex screws (two per bracket) and four plastic washers

• Washers are not required • Washers are required

88815

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sem comentários

Cisco IAD2431-1T1E1 Guia de Instalação Página 9