
Two-Way Cable
Cisco uBR7200 Series MC16S Cable Modem Card Spectrum Management 11
“Shared” indicates that upstream ports must share the same spectrum, and, therefore, must never be
set for overlapping carriers.
Note By default, upstream may overlap for all ports in the same spectrum group if this option is not
configured.
[no] cable spectrum-group
n
hop period
period-sec
[no] cable spectrum-group
n
hop threshold
thres-pcnt
hop
Indicates that a frequency hop parameter is to be configured for a period.
period-sec
Valid range is 1 to 3600 seconds. This parameter limits the frequency hop rate to a configured period
value in seconds. The configured value may be returned to its default of 300 seconds using the no
keyword.
thres-pcnt
Valid range is 0 to 100 percent.
Interface Configuration
Specify upstream channel width in Hz. Valid values are 200000, 400000, 800000, 1600000, and
3200000 based on the cable modem card used. The corresponding symbol rate is 160000, 320000,
640000, 1280000, and 2560000 symbols/sec. A default value of 1600000 Hz (1280000 symbols/sec)
is configured by the no keyword.
cable upstream
n
channel-width
width
[no] cable upstream
n
channel-width
width
The channel width set by this command determines the amount of spectrum needed during
frequency assignment.
[no] cable upstream
port
shutdown
shutdown (Default)
Disables the upstream port. In this mode, downstream UCD and MAP messages for the upstream
channel are disabled which inhibits the upstream transmitters on the cable modems.
Note Shutting down the interface does not prevent frequency assignment.
no...shutdown
Enables the upstream port. The operator must configure this option to enable data traffic.
[no] cable spectrum-group
groupnum
no...spectrum-group
(Default) Disable frequency agility.
groupnum
Comentários a estes Manuais