Cisco NM-16ESW - EtherSwitch Switch Manual do Utilizador descarregar pdf (Página 25)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

DETAILED STEPS

To return to the default quiet time, use the no dot1x timeout quiet-period command in global

configuration mode.

Changing the Switch-to-Client Retransmission Time

The client responds to the EAP-request/identity frame from the switch with an EAP-response/identity

frame. If the switch does not receive this response, it waits a set period of time (known as the

retransmission time), and then retransmits the frame.

Note You should change the default value of this command only to adjust for unusual circumstances such as

unreliable links or specific behavioral problems with certain clients and authentication servers.

Beginning in privileged EXEC mode, follow these steps to change the amount of time that the switch

waits for client notification:

SUMMARY STEPS

1. configure terminal

2. dot1x timeout tx-period seconds

3. end

4. show dot1x

Command Purpose

Step 1

configure terminal

Example:

Router#configure terminal

Enters global configuration mode.

Step 2

dot1x timeout quiet-period seconds

Example:

Router(config)#dot1x timeout

quiet-period seconds

Sets the number of seconds that the switch remains in the quiet state

following a failed authentication exchange with the client.

The range is from 0 to 65535; the default is 60.

Step 3

end

Example:

Router(config)#end

Returns to privileged EXEC mode.

Step 4

show dot1x

Example:

Router#show dot1x

Verifies your entries.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 89 90

Comentários a estes Manuais

Sem comentários

Cisco NM-16ESW - EtherSwitch Switch Manual do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco NM-16ESW - EtherSwitch Switch