Cisco PA-5EFL= Especificações descarregar pdf (Página 22)

22 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Conﬁguration

VIP2 and the 5EFL Port Adapter

The following example of the show interfaces ethernet slot/port adapter/port command shows all

of the information speciﬁc to the ﬁrst 5EFL interface port (interface port 0) in chassis slot 3, port

adapter slot 1:

Router# sh int e 3/1/0

Ethernet3/1/0 is administratively down, line protocol is down

Hardware is cyBus Ethernet, address is 0000.0ca5.2305 (bia 0000.0ca5.238e)

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255

Encapsulation ARPA, loopback not set, keepalive set (10 sec)

ARP type: ARPA, ARP Timeout 4:00:00

Last input never, output never, output hang never

Last clearing of "show interface" counters 2:56:26

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 input packets with dribble condition detected

0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets, 0 restarts

0 output buffer failures, 0 output buffers swapped out

Note For complete VIP2 command descriptions and examples, refer to the publications listed in

the section “If You Need More Information” on page 2.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Sem comentários

Cisco PA-5EFL= Especificações Página 22