Cisco PA-E3 Especificações descarregar pdf (Página 23)

VIP2 and the PA-E3 3-5

Installing a Port Adapter

Figure 3-4 Pulling a Port Adapter Out of a Slot—Partial Port Adapter View

Step 7

If you removed a port adapter, place it in an antistatic container for safe storage or

shipment back to the factory. If you removed a blank port adapter, no special handling is

required; however, store the blank port adapter for potential future use.

This completes the procedure for removing a new port adapter on a VIP2.

Installing a Port Adapter

Following is the standard procedure for replacing a port adapter on the VIP2:

Step 1 Attach an ESD-preventive wrist strap between you and an unﬁnished chassis surface.

Step 2 Remove the new port adapter from its antistatic container and position it at the opening

of the slot.

Step 3 Carefully align the port adapter carrier between the upper and the lower edges of the port

adapter slot, as shown in Figure 3-5.

H3149

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Sem comentários

Cisco PA-E3 Especificações Página 23