Cisco uBR900 Series Manual do Utilizador descarregar pdf

Password Recovery Procedure for the Cisco

uBR900 Series Routers

Document ID: 12750

Introduction

Prerequisites

Requirements

Components Used

Related Products

Conventions

Step−by−Step Procedure

Example of Password Recovery Procedure

Related Information

Introduction

This document describes how to recover the enable password and the enable secret passwords. These

passwords protect access to privileged EXEC and configuration modes. The enable password password can

be recovered, but the enable secret password is encrypted and must be replaced with a new password. Use the

procedure described in this document in order to replace the enable secret password.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on the Cisco uBR900 Series Routers.

The information in this document was created from the devices in a specific lab environment. All of the

devices used in this document started with a cleared (default) configuration. If your network is live, make sure

that you understand the potential impact of any command.

Related Products

Refer to Password Recovery Procedures for information on how to recover passwords for related products.

Conventions

Refer to Cisco Technical Tips Conventions for information on document conventions.

Step−by−Step Procedure

Follow these steps in order to recover your password:

Attach a terminal or PC with terminal emulation to the console port of the router.1.

1 2 3 4 5 6 7

Resumo do Conteúdo

Página 1 - Step−by−Step Procedure

Password Recovery Procedure for the CiscouBR900 Series RoutersDocument ID: 12750IntroductionPrerequisites Requirements Components Used

Use these terminal settings:9600 baud rate♦ No parity♦ 8 data bits♦ 1 stop bit♦ No flow control♦ Refer to these documents for information on how to ca

encrypted passwords to a new password.Type configure terminal.The hostname(config)# prompt appears.11. Type enable secret <password> in order to

Configuration register is 0x2102Router>!−−− The router was just powercycled, and during bootup a!−−− break sequence was sent to the router.!*** Sys

8192K bytes of processor board System flash partition 1 (Read/Write)8192K bytes of processor board System flash partition 2 (Read/Write) −−− System Co

BRI0/0:1 unassigned YES unset administratively down downBRI0/0:2 unassigned YES unset administratively down down

Página 7 - Related Information

Copyright (c) 1986−1999 by cisco Systems, Inc.Compiled Tue 07−Dec−99 02:21 by phanguyeImage text−base: 0x80008088, data−base: 0x80C524F8ROM: System Bo

Mais documentos para Redes Cisco uBR900 Series

Para ver o documento Cisco uBR900 Series Especificações

Cisco uBR900 Series Especificações (138 páginas)

Comentários a estes Manuais

Sem comentários