Cisco WS-X6381-IDS - Intrusion Detection System Module Manual do Utilizador descarregar pdf (Página 2)

10-2 Cisco Secure Intrusion Detection System 2.1Lab 10.9.1 Copyright  2001, Cisco Systems, Inc.

Your instructor will provide you with the values to complete the following table.

Parameter Value

PVLAN

Task 1—Initialize the IDSM

Perform the following lab steps to initialize the IDSM.

Step 1 From your Windows host, telnet to the switch.

c:> telnet SW

(where SW = IP address of switch)

Step 2 Disable console error messages during your telnet session into the switch.

switch> (enable) set logging session disable

Step 3 Session and log into your idsm:

switch> session M

(where M = module number assigned)

password: attack

Step 4 Run the setup command:

# setup

Step 5 Follow the system configuration dialog and enter the following CIDS

Communications Infrastructure parameters:

Parameter Value

IDSM virtual terminal password Keep the default setting of current

Sensor’s IP address 10.0.P.6 (where P = pod number)

Sensor’s IP subnet mask 255.255.255.0

Sensor’s default gateway 10.0.P.1 (where P = pod number)

Sensor’s host name idsmP (where P = pod number)

Sensor’s host id 6

Sensor’s host post office port 45000

Sensor’s organization name podP (where P = pod number)

Sensor’s organization id P (where P = pod number)

Director’s IP address 10.0.P.3 (where P = pod number)

Director’s host name directorP (where P = pod number)

Director’s host post office port Keep the default setting of 45000

Director’s host id 3

1 2 3 4 5 6 7 8

Sem comentários

Cisco WS-X6381-IDS - Intrusion Detection System Module Manual do Utilizador Página 2