Cisco 1231G - Aironet - Wireless Access Point Especificações descarregar pdf (Página 32)

Chapter2 Using the Management Interfaces

Using the Command-Line Interface

2-6

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-01

Preparing to Use a Terminal Emulator

To use a terminal emulator to open the CLI, you need to:

1. Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port

on the access point and to the COM port on a computer.

2. Set up a terminal emulator to communicate with the access point. Use the

following settings for the terminal emulator connection: 9600 baud, 8 data

bits, no parity, 1 stop bit, and no flow control.

Use the Console/Telnet Setup page to adjust the console and Telnet

connection settings. See the “Console and Telnet Setup” section on page 7-5

for details on the Console/Telnet Setup page.

Connecting the Serial Cable

Connect a DB-9 to RJ-45 serial cable to the COM port on a computer and to the

RJ-45 serial port on the access point. Figure 2-3 shows the serial port connection.

Figure 2-3 Connecting the Serial Cable

Note The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200.

Browse to http://www.cisco.com/go/marketplace to order a serial cable.

RJ-45 serial

connector

DB-9 to RJ-45

serial cable

74005

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 271 272

Sem comentários

Cisco 1231G - Aironet - Wireless Access Point Especificações Página 32