Cisco DMP100 Guia do Utilizador descarregar pdf (Página 13)

2. Field calibration

2.1 Quick start

Physical Connect

1. For D-320/DMP-100 based digitizer, connect COM port of digitizer with controller PC

Control PC

(A)

Digitizer (C) Fiberlink TX (D) Fiberlink RX (E)

Display

(B)

COM1 (F)

Optional (G)

Image 2-1

setup 1

A Computer

B Display devices

C D-320/DMP-100 based Digitizer

D FiberLink transmitter

E FiberLink receiver

FCOM1

Or,

For DX-700 based digitizer, connect it with controller PC via Ethernet.

Control PC

(A)

Digitizer (C)

Display

(B)

RJ-45 (D)

Ethernet

Intranet

Image 2-2

setup 2

A Computer

B Display device

C DX-700 based digitizer

D Ethernet connection

2. Double click on the software icon to run FSC-100

3. Conﬁguration

- (1) Click on Conﬁguration page;

- (2) Select connect mode; For D-320/DMP-100 based digitizer, select “RS232” connect mode, and press to conﬁgure the COM

port and bandrate.

- (3) For DX-700 based digitizer, select “ETHERNET” connect mode, and press to conﬁgure IP address, bank and output, which

is accordant with DX-700 .

- (4) Select LED type from drop down list;

- (5) Press “off” button to establish connection, Red “off” will change to Green “On”, And “Establish connection” is shown.

R59770395 FIELD CALIBRATION SOFTWARE (FCS-100) 08/05/09

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Comentários a estes Manuais

Sem comentários

Cisco DMP100 Guia do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com não Cisco DMP100