Cisco SFS 7008 Manual do Utilizador descarregar pdf (Página 48)

7. Install a blanking panel in place of the LIM module, or refer to “Installing a LIM Module” on

page 48 for instructions on replacing the LIM module.

Installing a LIM Module

1. Remove the new LIM module from the package.

2. Refer to “Removing a LIM Card” on page 45, if a LIM module is still in place.

3. Ground yourself appropriately.

4. Remove the blanking panel if a LIM module was not currently in place.

5. Align the LIM module and slide it into the bay as far as possible. The module will not go into the

bay completely without closing the levers.

6. When the LIM module is nearly installed in the bay, press the levers in toward each other.

Figure 3-17: Closing the LIM Module Levers

7. Check the LIM status LED to determine that the module is functioning properly. Refer to “LIM

Status LEDs” on page 75.

8. Tighten the captive screws on both ends of the LIM card.

Figure 3-18: Tighten the Captive Screws

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 107 108

Sem comentários

Cisco SFS 7008 Manual do Utilizador Página 48