Cisco MC3810 Guia de Instalação descarregar pdf (Página 10)

Configuring Dial Peers

Release 12.0(7)XK

To conﬁgure direct inward dial (DID) for a particular POTS dial peer, use the following commands

beginning in global conﬁguration mode:

Note Direct inward dial is conﬁgured for the calling POTS dial peer.

Note Direct inward dial is only conﬁgured on the POTS dial peer if it corresponds to a BRI or

PRI/QSIG interface. It should not beconﬁgured to correspondto an analog or T1/E1 CAS interface.

For additional POTS dial-peer conﬁguration options, refer to the “Voice-Related Commands”

section of the Cisco IOS 12.0 Voice, Video, and Home Applications Command Reference.

Conﬁgure VoIP Peers

VoIP peers enable outgoing calls to be made from a particular telephony device.To conﬁgure a VoIP

peer, you need to uniquely identify the peer (by assigning it a unique tag number), deﬁne its

destination telephone number and destination IP address. As with POTS peers, under most

circumstances, the default values for the remaining dial-peer conﬁguration commands will be

adequate to establish connections.

To enter the dial-peer conﬁguration mode (and select VoIP as the method of voice-related

encapsulation), use the following command in global conﬁguration mode:

The number valueof the dial-peer voice voip command is a tag that uniquely identiﬁes the dial peer.

To conﬁgure the identiﬁed VoIP peer, use the following commands in dial-peer conﬁguration mode:

2 router(config-dialpeer)# port

slot

port

Associate this POTS dial peer with a speciﬁc voice port.

Step Command Purpose

router(config)# dial-peer voice

number

pots

Enter dial-peer conﬁguration mode to conﬁgure a POTS peer.

router(config-dialpeer)#direct-inward-dial

Specify direct inward dial for this POTS peer.

Command Purpose

router(config)#dial-peer voice

number

voip Enter the dial-peer conﬁguration mode to conﬁgure a

VoIP peer.

Step Command Purpose

router(config-dialpeer)#destination-pattern

string

Deﬁne the destination telephone number associated with this

VoIP dial peer.

router(config-dialpeer)#session target

{ipv4:

destination-address

| dns:

host-name

| ras}

Specify a destination IP address for this dial peer.

Step Command Purpose

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 77 78

Comentários a estes Manuais

Sem comentários

Cisco MC3810 Guia de Instalação Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Máquinas de fax Cisco MC3810