Cisco 3750-48TS - Catalyst Switch - Stackable Guia de Instalação descarregar pdf (Página 161)

C-7

Catalyst 3750 Switch Hardware Installation Guide

OL-6336-01

Appendix C Configuring the Switch with the CLI-Based Setup Program

Connecting to the Console Port

You can use the console port to perform the initial configuration. To connect the

switch console port to a PC, use the supplied RJ-45-to-DB-9 adapter cable.

Note If you have stacked your switches, connect to the console port of one of the

switches in the stack. The initial configuration for the entire stack can be

performed on any switch in the stack.

Follow these steps to connect the PC or terminal to the switch:

Step 1 Using the supplied RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into

the console port on the rear of a switch, as shown in Figure C-4.

Step 2 Attach the DB-9 female DTE of the adapter cable to a PC’s serial port, or attach

an appropriate adapter to the terminal.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 173 174

Sem comentários

Cisco 3750-48TS - Catalyst Switch - Stackable Guia de Instalação Página 161