Cisco 1417 - 1417 Router - EN Manual do Utilizador descarregar pdf (Página 5)

Cisco 605

The Asymmetric Digital Subscriber Line (ADSL) port uses an RJ−11 connector.

ADSL Port Pinouts

Signal

Ring

Tip

Rear Panel LEDs

LED

Function Description

LNK ADSL

Link

On when a link is established on the ADSL

port. Blinks when a connection is

established.

ACT ADSL

Activity

On when the ADSL port transmits or

receives data.

Cisco 626

The ADSL port on a Cisco 626 uses an RJ−11 connector. It is labeled "WALL" on the rear panel.

ADSL Port Pinouts

Signal

Ring

Tip

Note: Pins 1, 2, 5, and 6 are not used.

WAN LNK LED

If the WAN LNK light does not turn on when you power up the modem:

Wait approximately fifteen seconds.1.

If the light does not turn on, check all cabling and connections.2.

If the light still does not turn on, turn off the power and then turn it on again.3.

If the LED is not on, call your service representative.4.

If the PWR/ALARM light appears red:

Turn off the power and then turn it on again.1.

If the LED still appears red, call your service representative.2.

Cisco − DSL Modem/Router Interface Pinouts and Status LED Descriptions

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sem comentários

Cisco 1417 - 1417 Router - EN Manual do Utilizador Página 5