Cisco 2511 - Router - EN Manual do Utilizador descarregar pdf (Página 11)

If you get a “Connection refused by remote host” message the telnet session is

suspended and you will have to clear the console line. To do this, enter the

following commands on your Commserver:

2511# clear line 1 clears line 1 (or ‘clear line 4’ for r4) so it’s

ready for new telnet sessions. For r2 enter

“clear line 2”, for r3 “clear line 3”, r4 “clear line

4”, etc.

Press the enter key to confirm the clearing of the line or repeat the

command until the line clears. Now try connecting to the router again as

explained above.

Verfiy that you successfully connected to the router by looking at the

hostname prompt.

Now that you have established a connection with your router you can begin

to configure and maneuver within that Cisco device using Cisco’s IOS

Software.

EXERCISE 2: Using “Show Commands”__________________________

First, enter privileged EXEC mode of the router, r1.

r1> enable

You should see a # sign next to router r1 now.

To find the version and system information about your router issue the

following commands:

r1# show version

NOTE: When you see “–More—“ press the spacebar to continue with the entire

output. To interrupt output press Ctrl-Z until it brings you back to the router

prompt.

1. What is the software image version?

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Cisco 2511 - Router - EN Manual do Utilizador Página 11