Cisco 3631 Especificações descarregar pdf (Página 85)

3-23

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 3 Configuring with the Command-Line Interface

Configuring Inverse Multiplexing for ATM Interfaces

To configure an inverse multiplexing for ATM (IMA) interface, you must use configuration mode

(manual configuration). In this mode, you enter Cisco IOS commands at the router prompt.

Note Before you begin, disconnect all WAN cables from the router to keep it from trying to run the

AutoInstall process. The router tries to run AutoInstall whenever you power it on, if there is a WAN

connection on both ends and the router does not have a valid configuration file stored in nonvolatile

random-access memory (NVRAM) (for instance, when you add a new interface). It can take several

minutes for the router to determine that AutoInstall is not connected to a remote Transmission

Control Protocol/Internet Protocol (TCP/IP) host.

This section describes basic configuration, including enabling the interface and specifying IP routing.

Depending on your own requirements and the protocols you plan to route, you might also need to enter

other configuration commands.

Note The T1/E1 physical layer information is configured underneath an interface called interface atm.

The ATM interfaces (representing the individual T1/E1 interfaces) are automatically created

depending on the configuration of the individual T1/E1 interfaces. You cannot directly add or delete

these interfaces.

Each port can be used as an independent T1/E1 ATM port with all the properties and functionality of

ATM interfaces. When the port becomes part of an IMA group, its ATM functionality ceases. At the

same time, the IMA group can use ATM commands.

Note On the 8-port E1 or T1 network module, only four ATM layer interfaces can be operational at the

same time. All the interfaces can be activated (configured as “no shutdown”) but only four at a time

can be operational and pass network traffic.

Configuring the ATM T1/E1 Interface

To configure the ATM interface, follow this procedure:

Command Purpose

Step 1

Router> enable

Password: password

Router#

Enter enable mode. Enter the password.

You have entered enable mode when the prompt

changes to

Router#.

Step 2

Router# configure terminal

Enter configuration commands, one per line.

End with CNTL/Z.

Router(config)#

Enter global configuration mode. You have

entered global configuration mode when the

prompt changes to

Router(config)#.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 197 198

Comentários a estes Manuais

Sem comentários

Philips PAS250/00 Scheda Tecnica (2 pagine)

Marchio: Philips | Categoria: MP3/MP4 players | Dimensione: 0.78 MB |

Indice

2nd black

Più prodotti e manuali per Lettori MP3/MP4 Philips

Modelli	Tipo di Documento
SA018102S/37	Scheda Tecnica Philips SA018102S, 2 pagine
SA1340/02	Scheda Tecnica Philips GoGear Flash audio player SA1340, 2 pagine
SA1345/02	Scheda Tecnica Philips 512MB Flash Audio Player, 2 pagine
SA179/00	Scheda Tecnica Philips 1GB Flash audio player, 2 pagine
SA178/02	Scheda Tecnica Philips 512MB Flash audio player, 2 pagine
SA3245/02	Scheda Tecnica Philips GoGear Portable video player SA3245, 2 pagine
SA1305/02	Scheda Tecnica Philips Go Gear Flash audio player SA1305, 2 pagine
SA1926/55	Scheda Tecnica Philips SA1926 2GB* Flash audio player, 2 pagine
SA2313/37	Scheda Tecnica Philips SA2313 1GB* Flash audio player, 2 pagine
SA4015/02	Scheda Tecnica Philips Flash audio player SA4015, 2 pagine
SA2120/02	Scheda Tecnica Philips GoGear Flash audio player SA2120, 2 pagine
SA164/00	Scheda Tecnica Philips Flash audio player, 2 pagine
HDD085/00	Scheda Tecnica Philips Micro jukebox 3GB, 2 pagine
ACT211/00C	Scheda Tecnica Philips ACT211/05 Datasheet, 42 pagine
PSA220	Scheda Tecnica Philips 256MB Digital Audio Player, 2 pagine
SA1105/55	Scheda Tecnica Philips SA1105 512MB* Flash audio player, 2 pagine
SA2618/93	Scheda Tecnica Philips SA2618 1GB* Flash audio player, 2 pagine
SA2427BT/97	Scheda Tecnica Philips SA2427BT 2GB* Digital MP3 player, 3 pagine
SA2627/37	Scheda Tecnica Philips SA2627 2GB* Flash audio player, 2 pagine
SA1929/37	Scheda Tecnica Philips SA1929 2GB* Flash audio player, 2 pagine

Cisco 3631 Especificações Página 85

Comentários a estes Manuais

Philips PAS250/00 manuali

Philips PAS250/00 Scheda Tecnica (2 pagine)

Indice

Più prodotti e manuali per Lettori MP3/MP4 Philips

Cisco 3631 Especificações Página 85

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco 3631

Philips PAS250/00 manuali

Philips PAS250/00 Scheda Tecnica (2 pagine)

Indice

Più prodotti e manuali per Lettori MP3/MP4 Philips