Cisco 3800 Series Guia de Instalação descarregar pdf (Página 9)

Cisco 3800 Series Integrated Services Routers: Overview

OL-6339-01

Using the Cisco IOS Startup Sequence

Step 3 Use HyperTerminal or a similar terminal emulation program on your PC—with the terminal emulation

settings of 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control—to open a terminal session

with the router.

Step 4 At the prompt, enter the enable command. The default configuration file does not configure an enable

password:

yourname> enable

yourname#

Step 5 Enter the erase startup-config command:

yourname# erase startup-config

Step 6 Confirm the command by pressing Enter.

Step 7 Enter the reload command:

yourname# reload

Step 8 Confirm the command by pressing Enter.

The router begins executing the standard startup sequence. If you want to use SDM to perform

subsequent configurations for the router, you must reconfigure the router manually to support web-based

applications and the Telnet and SSH protocols. You must also create a user account with a privilege level

of 15. See the “Enabling SDM on a Router Configured to Use the Cisco IOS Startup Sequence” section

on page 9 for information.

Enabling SDM on a Router Configured to Use the Cisco IOS Startup Sequence

If you erased the factory startup configuration to use the Cisco IOS startup sequence, you can still use

SDM. To use SDM, you must configure the router to support web-based applications, configure it with

a user account defined with privilege level 15, and then configure it to support the Telnet and SSH

protocols. These changes can be made using a Telnet session or using a console connection.

Configuring the Router to Support Web-Based Applications, a User with Privilege Level 15, and

Telnet and SSH Protocols

To configure a router to support web-based applications, a user with privilege level 15, and Telnet and

SSH protocols, follow these steps:

Step 1 Enable the HTTP/HTTPS server on the router, using the following Cisco IOS commands in the global

configuration mode:

Router(config)#ip http server

Router(config)#ip http secure-server

Router(config)#ip http authentication local

If the router uses an IPSec IOS image, the HTTPS server is enabled first. Otherwise only the HTTP

server is enabled.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Cisco 3800 Series Guia de Instalação Página 9