Cisco 675E Guia do Utilizador descarregar pdf (Página 18)

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure Applications

5-18

Cisco 600 Series Installation and Operation Guide

78-11190-01

Configure Applications

The Cisco 67x supports these applications for system management and control:

• DHCP client

• DHCP server

• NAT

• RADIUS client

• SNMP

• SYSLOG client

• Telnet server

• TFTP server

• Web server (HTTP server)

DHCP Client

The DHCP client requests an IP address from a DHCP server. To enable the

DHCP client:

Note Enabling the DHCP client automatically disables the DHCP server

on the CPE.

Step 1 Enable the DHCP client:

set dhcp client enabled

Step 2 To change the DHCP client interface, enter:

set dhcp client interface eth0

Step 3 To check whether this feature is enabled, enter:

show dhcp client

Step 4 Write the changes to NVRAM:

write

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Sem comentários

Cisco 675E Guia do Utilizador Página 18