Cisco 675E Guia do Utilizador descarregar pdf (Página 43)

5-43

Cisco 600 Series Installation and Operation Guide

78-11190-01

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure Static NAT

Step 9 To program the area of memory to Flash, enter:

pb 10008000 fef00000

xxxxxxxx

where xxxxxxxx is the value recorded in Step 6.

Step 10 To turn debug monitor off, enter:

Step 11 To reboot, enter:

Configure Static NAT

Prior to following these steps, contact your application vendor to find out which

ports they use.

Step 1 At the command prompt of the CPE, enter:

cbos#enable

Step 2 Enter:

set nat entry add

inside-ip-addr inside-port outside-ip-addr

outside-port protocol

where protocol is UDP, TCP or ICMP. The default local CPE services ports are:

Service Protocol Port

Telnet TCP 23

TFTP UDP 69

SNMP UDP 161

Web Server TCP 80

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49 50

Sem comentários

Cisco 675E Guia do Utilizador Página 43