Cisco 820 Series Manual do Utilizador descarregar pdf (Página 11)

Configuration Note for the Cisco SOHO 76 and 77 Routers

OL-2479-02

Configuration Instructions

Follow these steps to configure the router for MMI support in configure-terminal mode:

Step 1 To set the configuration approach for MMI, enter one of the following commands:

mmi auto-configure

no mmi auto-configure

If the auto-configure parameter is enabled, the router is provisioned by the PE. By default, this parameter

is enabled.

If the auto-configure parameter is disabled, the router is configured by the startup configuration file.

Step 2 To set the polling interval for the router to check the PE for any updated image or configuration files,

enter the following command:

mmi polling-interval time

where time is the number of seconds. The polling-interval range is from 1 to 65535, with the default set

to 60 seconds.

Step 3 To set the ATM PVC so the MMI communicates with the PE, enter the following command:

mmi pvc vpi/vci

where vpi/vci is the virtual path identifier/virtual channel identifier. The default PVC for MMI is 0/16

ilmi, but if it is not available, you must set the specific PVC for the router to communicate with the PE.

Step 4 To set the timer to monitor the image file download, enter the following command in configure terminal

mode:

mmi snmp-timeout time

where time is 1 to 1800 seconds, which is the allowed interval for downloading any two consecutive

blocks. If you enter the no mmi snmp-timeout command, the default time is set to 180 seconds.

Step 5 To eliminate the ADSL line training delay, enter the following command:

dsl operating-mode auto

If the DSLAM is using a Cisco 4xDMT ADI-based card, enter the following command:

dsl operating-mode ansi-dmt

Step 6 To set up the debug process for MMI, enter the following command:

debug mmi

Step 7 Save the configuration file to NVRAM, and enter the reload command. The router’s OK LED on the

front panel blinks while the image is being auto-provisioned. The PVC is set up when the reboot occurs.

MMI Configuration Example

The following example shows an MMI configuration:

SOHO-voice1#sh run

Building configuration...

Current configuration :947 bytes

version 12.1

no service single-slot-reload-enable

no service pad

service timestamps debug uptime

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Cisco 820 Series Manual do Utilizador Página 11