Cisco 820 Series Manual do Utilizador descarregar pdf (Página 3)

Configuration Note for the Cisco SOHO 76 and 77 Routers

OL-2479-02

New and Changed Information

This section describes information that has changed from previous software releases. A number of

configuration commands, and show and debug commands run from EXEC mode, are no longer available

on the Cisco SOHO 76, 77, and 77H routers. The configuration commands are no longer necessary. The

show and debug commands have been replaced by new commands that are described in the “Command

Reference” section on page 4.

clear vpdn tunnel pppoe Command No Longer Supported

The following virtual private dial-up network (VPDN) clear commands will no longer work for

Point-to-Point Protocol over Ethernet (PPPoE) client sessions.

clear vpdn tunnel pppoe

This command has been replaced by the clear pppoe command, which is described in the “Command

Reference” section on page 4.

debug Commands No Longer Supported

The following VPDN debug commands will no longer work for PPPoE client sessions:

• debug vpdn pppoe-event

• debug vpdn pppoe-error

• debug vpdn pppoe-packet

• debug vpdn pppoe-data

These commands have been replaced by the debug pppoe command, which is described in the

“Command Reference” section on page 4.

show Commands No Longer Supported

The following VPDN show commands will no longer work for PPPoE client sessions.

• show vpdn tunnel

• show vpdn session

• show vpdn

These commands have been replaced by the show pppoe session command, which is described in the

“Command Reference” section on page 4.

vpdn Configuration Commands No Longer Supported

The following commands are no longer necessary for configuring a PPPoE client on a SOHO 77 or 77H

router:

• vpdn enable

• vpdn group number

See the “Configuring PPP over Ethernet” section on page 8 for new configuration instructions.

1 2 3 4 5 6 7 8 ... 15 16

Sem comentários

Cisco 820 Series Manual do Utilizador Página 3