Cisco SGE2000 Especificações descarregar pdf (Página 10)

Chapter

Chapter 2: Getting to Know the Switch

The Back Panel

Linksys One Ready Communications Solution

Uplink Ports

The Switch is equipped with 4 mini-GBIC uplink ports.

The Back Panel

The power port is located on the back panel of the Ethernet switch.

Power Port

The 100-240 VAC power cord is connected to the Power port.

GBIC1-4 The Switch provides four mini-GBIC ports. The mini-GBIC port is a

connection point for a mini-GBIC expansion module, so the Switch can

be uplinked via fiber or copper to another switch. Each mini-GBIC port

provides a link to a high-speed network segment or individual

workstation at speeds of up to 1000Mbps.

Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules

with the Switch. The MGBSX1 and the MGBLH1 require fiber cabling

with LC connectors, while the MGBT1 requires a Category 5e Ethernet

cable with an RJ-45 connector.

CAUTION: Only use the power cord

that is supplied with the Ethernet switch.

The unit may be damaged if the

incorrect power cord is used.

DC INPUT FOR REMOTE

POWER SUPPLY SPECIFIED

IN MANUAL +12V, 7.5A

Power Port. The Power port is where you will

connect the power cord. For more details, refer to

”Power Port,” on page 6.

Console Port. The Console port is where you can

connect a serial cable to a PC’s serial port for

configuration. For more details, refer to ”Console

Port,” on page 7

RPS Port. Redundant Power Supply (RPS) port. For

more details, refer to

”RPS Port,” on page 7.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Sem comentários

Cisco SGE2000 Especificações Página 10