Cisco SGE2000 Especificações descarregar pdf (Página 12)

Chapter

Chapter 3: Connecting the Switch

Overview

Linksys One Ready Communications Solution

Connecting the Switch

Overview

This chapter will explain how to connect network devices to the Ethernet switch. For an

example of a possible network configuration, see the application diagrams shown below.

Before You Install the Switch...

When you choose a location for the Ethernet switch, observe the following guidelines:

• Make sure that the Ethernet switch will be accessible and that the cables can be easily

connected.

• Keep cabling away from sources of electrical noise, power lines, and fluorescent lighting

fixtures.

• Position the Ethernet switch away from water and moisture sources.

• To ensure adequate air flow, be sure to provide a minimum clearance of two inches

(50 mm) around the air intake and exhaust ports on the sides of the Ethernet switch.

• Do not stack free-standing Ethernet switches more than four units high. The stacking

configuration, described in ”Stacking Multiple Switches,” on page 12, allows up to eight

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

Sem comentários

Cisco SGE2000 Especificações Página 12