Cisco Blower Module 10000 ESR Guia de Instalação descarregar pdf (Página 241)

18-19

Cisco 10000 Series Routers Line Card Hardware Installation Guide

OL-6773-04

Chapter 18 Troubleshooting the Installation

Fast Ethernet and Gigabit Ethernet Line Card Troubleshooting Information

An SFP module with

the same serial

number as another

SFP module is

inserted. Both are

Cisco-supported

Gigabit Ethernet

SFP modules.

The FAIL LED is

blinking on the line card

in which the second SFP

module was inserted.

%C10KGE1H-6-SFP_OK: Interface GigabitEthernet1/0/0, 1000BASE-SX

Gigabit ethernet module (SFP) inserted

%C10KGE1H-3-SFP_SPURIOUS: Interface GigabitEthernet1/1/0, Gigabit

ethernet module (SFP) is a duplicate spurious

%C10K_ALARM-6-INFO: ASSERT CRITICAL GigE1H 1/1/0 C10K

Gigabit Ethernet SFP module spurious

An SFP module

hardware problem

occurs.

The FAIL LED will

blink when there is a TX

fault as long as the

invalid SFP module

causing the error

situation is present.

%C10K-3-LC_ERR: Slot[8/1] Line-card Port 0: GBIC HW TX Fault

Table 18-4 SFPs and Cisco IOS Console Messages (continued)

Situation Response/Description Console Message

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 253 254

Sem comentários

Cisco Blower Module 10000 ESR Guia de Instalação Página 241