Cisco Unified Videoconferencing Manager Manual do Utilizador descarregar pdf (Página 56)

Direct Registration of Polycom Telepresence Systems with the Cisco Unified Communications Manager

Polycom, Inc. 49

Task 4: Configure an Ad Hoc Entry Queue on the RMX (if DMA

system is not used)

If your deployment does not include a DMA system, you must configure an

Ad Hoc Entry Queue for the RMX system. Be sure to use a conference profile

that is TIP enabled.

1 Create or select the Entry Queue as described in the RMX Administrator’s

Guide, “Entry Queues”.

2 In the New Entry Queue or Entry Queue Properties dialog box, ensure

that Ad Hoc is selected.

3 Ensure that the Entry Queue is designated as the Transit Entry Queue as

described in the RMX Administrator’s Guide, “Setting a Transit Entry

Queue”.

Task 5: Configure a Meeting Room on the RMX

For more information see the RMX Administrator’s Guide, “Creating a New

Meeting Room”.

Task 6: Configure Participant Properties for dial out calls

You need to configure the Participant Properties to ensure that defined

participants inherit their TIP settings from the Profile assigned to the Meeting

Room.

1 Define the New Participant’s General settings. For more information see

the RMX Administrator’s Guide, “Adding a Participant to the Address Book”.

2 Click the Advanced tab.

3 Ensure that:

— Video Bit Rate is set to Automatic or at least equal to or greater than

the value specified by the

MIN_TIP_COMPATIBILITY_LINE_RATE

System Flag.

— Resolution is set to Auto or at least HD 720.

— Video Protocol is set to Auto or at least H.264.

Task 7: Configure the RMX system for your H.323 gatekeeper

If your RMX system also supports H.323 calls, you can to configure the RMX

system’s H.323 Service to register with a gatekeeper.

For more information see the RMX Administrator’s Guide.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 116 117

Sem comentários

Cisco Unified Videoconferencing Manager Manual do Utilizador Página 56