Cisco Unified Videoconferencing Manager Manual do Utilizador descarregar pdf (Página 89)

Polycom Unified Communications for Cisco Unified Communications Manager Environments

82 Polycom, Inc.

Task 2: Create a trunk

You need to add an H.225 trunk.

To add a trunk:

1 Navigate to Device > Trunk.

2 Click Add New in the upper left.

3 Select H.225 Trunk (Gatekeeper Controlled). Then click Next.

4 Enter a Device Name for this trunk, and a description.

Fill out all other fields as appropriate for your system and location.

5 In the Gatekeeper Information area, select the gatekeeper created earlier.

6 Select Gateway for the Terminal Type.

7 Fill in the appropriate Technology Prefix (for example, 1#).

8 Fill in the appropriate Zone name.

9 Once all the fields are filled in correctly, click Save.

10 After saving, click Reset, then Reset to force the Cisco Unified

Communications Manager to register to the gatekeeper.

To verify that your Cisco Unified Communications Manager is registered to

the gatekeeper, check to see that your Cisco Unified Communications

Manager is an active endpoint on the gatekeeper. See “Basic Cisco IOS

Gatekeeper Monitoring” on page 72 for more information.

Task 3: Configuring Route groups, Route lists and Route Patterns

In this task, you create everything the Cisco Unified Communications

Manager needs to route calls to the H.323 network, as well as receive them.

Video calls are an automatic negotiation as part of the call setup.

• A route group in Cisco Unified Communications Manager is a collection of

gateways and trunks.

• A route list is a collection of route groups that Cisco Unified

Communications Manager can route calls through.

• The route pattern defines what specific dial pattern or patterns may be sent

to a route list.

Note

Do not check the Media Termination Point Required check box.

Note

Zone names are case-sensitive.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 116 117

Sem comentários

Cisco Unified Videoconferencing Manager Manual do Utilizador Página 89