Cisco 820 Series Guia de Instalação descarregar pdf (Página 6)

1-6

Cisco 820 Series and SOHO Series Router Cabling and Setup

78-13937-04

Chapter 1 Cisco 820 Series and SOHO Series Routers Cabling and Setup

Connect the Router to a Hub (Optional)

If you have PCs connected to a hub, follow the steps shown in Figure 1-2 on page 1-6 to connect the

router to a hub. Figure 1-2 shows portions of two router back panels. Refer to the back panel that is

similar to the back panel of the router that you are installing.

Figure 1-2 Connecting the Router to a Hub

Verify that the TO HUB/TO PC switch on the left side of the back panel has been set to the TO HUB

position (in). If the button is out, press it to set it to the in position. You will know that the position is

correct if the LED for this port on the front of the router lights after the router and the PCs have been

turned on.

Note You must use a crossover cable to connect a hub to an Ethernet port other than the ETHERNET 4 port

on Cisco 827H, Cisco 828, SOHO 77H or SOHO 78 routers. Crossover cables must be purchased

separately.

ETHERNET 10BASE T

TO HUB

TO PC

43 2 1

Model Cisco 828

G.SHDSL

CONSOLE

ETHERNET

TO HUB

TO PC

+5,+12,-12,-24,-71 VDC

CONSOLE

Model Cisco 827-4V

ADSL

PHONE

143

74082

ETHERNET

SPEED

LED

100BaseTX

SOLID

10BaseT BLINK

1X 2X 3X 4X

5X 6X 7X

MDI MDI-X

4. If applicable, check setting

of hub equivalent of router

TO HUB/TO PC button.

3. Connect other

end of cable

to hub.

Cisco 1528 Micro Hub 10/100

2. Connect yellow cable to

ETHERNET port on router.

1. Set TO HUB/TO PC

button.

1. Set TO HUB/TO PC

button.

2. Connect yellow cable to

ETHERNET port on router.

Cisco 827, Cisco 827-4V,

or SOHO 77 router

Cisco 827H, Cisco 828,

SOHO 77H, or

SOHO 78 router

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comentários a estes Manuais

Sem comentários

Cisco 820 Series Guia de Instalação Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco 820 Series