Cisco Cisco Access Registrar 4.2 Especificações descarregar pdf (Página 466)

100

101

10-24

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 10 Configuring Radio Resource ManagementWireless Device Access

Overriding Dynamic RRM

• detail—Enables debugging for RRM detail logs.

• error—Enables debugging for RRM error logs.

• group—Enables debugging for the RRM grouping protocol.

• manager—Enables debugging for the RRM manager.

• message—Enables debugging for RRM messages.

• packet—Enables debugging for RRM packets.

• power—Enables debugging for the RRM power assignment protocol.

• profile—Enables debugging for RRM profile events.

• radar—Enables debugging for the RRM radar detection/avoidance protocol.

• rf-change—Enables debugging for RRM RF changes.

Overriding Dynamic RRM

In some deployments, it is desirable to statically assign channel and transmit power settings to the access

points instead of relying on the dynamic RRM algorithms provided by Cisco. Typically, this is true in

challenging RF environments and non-standard deployments but not the more typical carpeted offices.

Note If you choose to statically assign channels and power levels to your access points and/or to disable

dynamic channel and power assignment, you should still use automatic RF grouping to avoid spurious

rogue device events.

You can disable dynamic channel and power assignment globally for a controller, or you can leave

dynamic channel and power assignment enabled and statically configure specific access point radios

with a channel and power setting. Follow the instructions in one of the following sections:

• Statically Assigning Channel and Transmit Power Settings to Access Point Radios, page 10-25

• Disabling Dynamic Channel and Power Assignment Globally for a Controller, page 10-28

Note While you can specify a global default transmit power parameter for each network type that applies to

all the access point radios on a controller, you must set the channel for each access point radio when you

disable dynamic channel assignment. You may also want to set the transmit power for each access point

instead of leaving the global transmit power in effect.

Note You can also override dynamic RRM using the Cisco Wireless Control System (WCS). Refer to the Cisco

Wireless Control System Configuration Guide for instructions.

1 2 ... 461 462 463 464 465 466 467 468 469 470 471 ... 635 636

Comentários a estes Manuais

Sem comentários

Cisco Cisco Access Registrar 4.2 Especificações Página 466

Comentários a estes Manuais