Cisco GoQAM Informações Técnicas descarregar pdf (Página 98)

Cha

4 Module Mode Commands

74 4025561

Rev

set control

Syntax

set control controlName controlValue

Description

The set control command is followed by two additional arguments: controlName

identifies the control parameter, and controlValue specifies the value to be assigned.

Important: To avoid possible system disruption, broadcast set commands are not

supported. This means that the set control command can only be applied to one

module (chassis and slot number) at a time. If a specific chassis and slot number are

not specified in advance, the CLI interpreter will disallow the command. In addition,

the name of the control to be changed must be explicit; no wildcard characters are

permitted.

Control Types

Control parameters are classified as type F (floating-point) or type S (state) to

characterize the types of variables they control. In general:

 Type F controls are numeric values that can vary between maximum and

minimum thresholds. The adjustment increments are set by separate hysteresis

values for each control.

 Type S controls are state variables that have a limited range of discrete values

such as On or Off, Master or Slave, Auto or Manual, and so on. The set of

possible values is defined as appropriate for each control.

Parameters

The possible values for controlName and controlValue depend on the application

module in question. The following tables identify the controls for each application

module along with their types and possible values.

Note: When selecting control parameters for this command, one or more wildcard

characters (*) may be used to specify a range of matching responses.

Transmitter (devtype: 1033)

Control Description Type Possible Values

Enable Enables or disables the laser. S On (1), Off (0)

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 307 308

Sem comentários

Cisco GoQAM Informações Técnicas Página 98