Cisco ISE - Line Card ISE Manual do Utilizador descarregar pdf (Página 23)

Cisco IOSSoftware Configurationforthe Cisco12000Series One-PortChannelized OC-12/STM-4(DS1/E1)ISE Line

How to Configure Layer 1 Features

Cisco IOS Release 12.0(27)S1

Entering TUG-3 Configuration Mode

To configure a TUG-3, use the au-4 au-4-number tug-3 tug-3-number controller configuration command

to enter TUG-3 configuration mode, which is indicated by a change in the command prompt. Table 4

describes the syntax of this command.

In the example that follows, the second TUG-3 of the AU-4 of the 1-Port CHOC-12 ISE line card in slot

4 of a Cisco 12000 Series Router is selected for configuration:

Router(config)# controller sonet 4/0

Router(config-controller)# framing sdh

Router(config-controller)# aug mapping au-4

Router(config-controller)# au-4 1 tug-3 2

Router(config-ctrlr-tug3)#

Entering AU-3 Configuration Mode

To configure an AU-3, use the au-3 au-3-number controller configuration command to enter AU-3

configuration mode, which is indicated by a change in the command prompt. au-3-number is a number

in the range from 1 to 3.

In the example that follows, the second AU-3 the 1-Port CHOC-12 ISE line card in slot 4 of a

Cisco 12000 Series Router is selected for configuration:

Router(config)# controller sonet 4/0

Router(config-controller)# framing sdh

Router(config-controller)# aug mapping au-3

Router(config-controller)# au-3 2

Router(config-ctrlr-au3)#

Table 3 au-4 tug-3 Command Syntax

Range Description

aug-4-number 1 to N A number in the range from 1 to N, where N is the

STM level. (For the 1-Port CHOC-12 ISE line card, N

is 12.)

tug-3-number 1 to 3 A number in the range from 1 to 3.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 57 58

Sem comentários

Cisco ISE - Line Card ISE Manual do Utilizador Página 23