Cisco ISE - Line Card ISE Manual do Utilizador descarregar pdf (Página 39)

Cisco IOSSoftware Configurationforthe Cisco12000Series One-PortChannelized OC-12/STM-4(DS1/E1)ISE Line

Configuring the Serial Interfaces

Cisco IOS Release 12.0(27)S1

Configuring Automatic Protection Switch

On the 1-Port CHOC-12 ISE line card, you configure APS at the SONET controller level, and not at the

interface level as in Packet-Over-Sonet.

The minimum configuration tasks to complete for configuring APS are as follows:

• Configure APS working and protect interfaces

Use the aps working and the aps protect controller configuration commands to specify the working

and protect channels.

• Configure other APS features (Optional)

Other APS features include the following:

–

group

–

lockout

–

manual

–

reflector

–

revert

–

signalling

–

timers

–

unidirectional

• Monitor and maintain APS (Optional)

Use the show aps, show controllers sonet, and show interfaces EXEC commands to monitor APS

configurations.

• Configure SONET Alarm Reporting (Optional)

For procedures on how to configure automatic protection switching on the 1-Port CHOC-12 ISE line

card, see the document, Automatic Protection Switching of Packet-over-SONET Circuits, at the following

URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/ios112p/gsr/posapsgs.htm

Two SONET connections are required to utilize APS and, in a Telco environment, the SONET circuits

must be provisioned for APS. At the time of provisioning, the operation (ie. 1+1), mode (ie.

bidirectional) and revert operation (that is, no revert) need to be specified. If the SONET connections are

homed on two separate routers (the normal configuration), then a communications channel between the

two routers (NOT utilizing the working and protect SONET circuits) needs to be set up for APS

communication.

In enabling APS operation, it is recommended to configure the working channel first. Normal operation

with 1+1 operation is to configure it as working channel 1.

Configuration on the router hosting the working channel:

Router# configure terminal

Router(config)# interface ethernet 0/0

Router(config-if)# ip address 7.7.7.7 255.255.255.0

Router(config-if)# exit

Router(config)# controller sonet 4/0

Router(config-controller)# aps working 1

Configuration on the router hosting the protect channel:

Router# configure terminal

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 57 58

Comentários a estes Manuais

Sem comentários

Cisco ISE - Line Card ISE Manual do Utilizador Página 39

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco ISE - Line Card ISE