
525
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S10
Conditions: This symptom is observed when the ingress is E2 and the egress is E5.
Workaround: There is no workaround.
Further Problem Description: This issue is not seen with an E3/E5 combination or an E2/E6
combination.
• CSCsj23805
Symptoms: Using the show isis timers causes the router crashes.
Conditions: Occurred on a router running Cisco IOS Release 12.0(31)S2y.
Workaround: There is no workaround.
• CSCsj59130
Symptoms: A router crashes when QoS is configured on POS and traffic line rate is sent.
Conditions: This symptom is observed whenQoS and above line rate traffic.
Workaround: Remove QoS.
• CSCsj78019
Symptoms: Buffers on a line card are depleted, causing the LC to stop transmitting packets and
possibly reset.
Conditions: E3/E5 on Tx side may have buffer depletion if running a defective image that corrupts
the OQ to 0.
Workaround: Reload the line card.
• CSCsj88891
Symptoms: A console message is displayed with an unknown MPLS peer and VCID.
Conditions: This symptom is observed after the xconnect configuration is deleted.
Workaround: There is no workaround.
• CSCsk14495
Symptoms: A bogus line card crash is reported during a PLIM reset.
Conditions: This symptom is observed during a PLIM reset.
Workaround: There is no workaround.
• CSCsk15805
Symptoms: If you shut down a TE tunnel interface and you have a static route through the tunnel,
the routing table is not updated immediately but only when the static scan runs (every minute by
default).
Conditions: This problem is fine if the static route is pointing to a physical interface and happens
only with TE tunnel interfaces when it is configured with the ip routing protocol purge command.
Workaround: Remove the ip routing protocol purge command or tune the adjust timer (ip route
static adjust-time command).
• CSCsk30571
Symptoms: Field diagnostics fail (indicating a DOWNLOAD FAILURE) on the standby PRP2 when
the PRP2 has 4 GB of memory installed.
After 40 minutes, the default download time limit, field diagnostics declare a download failure and
reload the board. The failure message for this looks like the following:
Field Diagnostic: ****DOWNLOAD FAILURE**** while preparing slot {#}
Comentários a estes Manuais