
433
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(33)S2
2. Configure one loopback interface.
• CSCsq27365
Symptoms: A router can crash at l2tp_process_control_packet_cleanup.
Conditions: Conditions are unknown at this time.
Workaround: There is no workaround.
• CSCsq28627
Symptoms: CPU hogs are seen in a 1-port E3 channelized OC48.
Conditions: This symptom is observed when any of the following is done:
–
controller shut/no shut
–
mic reload <slot>
–
hw-mod slot <xx> shut/no shut
–
hw-module slot <xx> reload
Workaround: There is no workaround.
• CSCsq42001
Symptoms: The following error messages appear:
SLOT 5:*May 9 21:43:48.547: %LC_SPA_DMLP-1-SPAHWBUNDLEERROR: Could not perform
required operation in SPA H/w for bundle Multilink2 in bflc_cx3_dmlp_frag_on_off SLOT
5:*May 9 21:44:10.727: %SPA_CHOC_DSX-3-ERROR: Multilink2 (cmd 203) Serial5/0/1/8:0:
response parsing failed. chnl 36, bid 1 -Traceback= 40031008 408924C0 4072B1BC
40899F64 4033DB90 4033E190 4033E5C0 4033E930 4033F448 4033F600 4015B53C 4015C020 SLOT
5:*May 9 21:44:10.735: %LC_SPA_DMLP-3-CFG_FAIL: bundle Multilink2 (id 1): bay 0 err
7 (del rx link)
Conditions: When we remove/add/remove all members from all the configured MLP bundles once
or several times, these tracebacks are seen.
Workaround: There is no workaround.
Further Problem Description: spabrg EFC mapping goes to a mismatch state, and the following is
seen:
SLOT 5:*May 9 21:59:26.771: %SPA_CHOC_DSX-3-HDLC_CTRL_ERR: SPA 5/0: 20 TX Chnl Queue
Overflow events on HDLC Controller were encountered.
• CSCsq42803
Symptoms: The hw-module slot x qos account layer2 encapsulation command does not take effect
for an AToM connection.
Conditions: This symptom is observed when xconnect is configured under a VLAN.
Workaround: There is no workaround.
• CSCsq44052
Symptoms: When configuring “is-type level-1” under “router isis”, the following error message may
be received:
% Ambiguous command: “is-type level-1”
Conditions: The symptom is observed when configuring “is-type level-1” under “router isis”.
Workaround: There is no workaround.
• CSCsq44598
Symptoms: A PA-POS-2OC3 experiences an output stuck condition.
Comentários a estes Manuais