Cisco OL-4015-08 Manual do Utilizador Página 416

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 678
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 415
768
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S3
show hw-module subslot subslot-number status command.
Conditions: This symptom is observed when you enter above-mentioned commands on the console
of a Cisco 7304 or on the console of a line card on a Cisco 7600 series or Cisco 12000 series when
these routers are configured with any of the following SPAs (some SPAs are specific to the
Cisco 7304 and some to the Cisco 12000 series):
2-port Gigabit Ethernet SPA
4-port FE SPA
CT3 SPA
T1/E1 SPA
T3/E3 SPA
Workaround: There is no workaround.
CSCeh63002
Symptoms: Service connections that are established with the xconnect command fail intermittently.
Conditions: This symptom is observed with both large configurations (with more than
4000 Xconnect service connections) and medium configurations (with 1000 Xconnect service
connections) when several changes such as OIRs or dynamic reconfigurations occur. The symptom
is intermittent and very unlikely to occur in small configurations, and it is unlikely to occur in large
configurations that do not undergo changes.
Workaround: There is no workaround. You must re-establish the service connections by re-entering
the xconnect command.
CSCeh80649
Symptoms: When a T3 line flaps, the serial interface that is configured on the T1 channel group
(over the T3 line) may fail to come up and may stay in the “Line Protocol down” state.
Conditions: This symptom is observed on a Cisco 7600 series and Cisco 12000 series that are
configured with a channelized T3 to DS0 SPA or 1-port channelized STM-1/OC-3 SPA that is
configured with channelized T1 serial interfaces.
Workaround: Reload the SPA by entering the hw-module subslot slot/subslot reload command.
CSCeh85133
Symptoms: A memory leak may occur when an SNMP trap is sent to a VRF destination. The output
of the show processes memory command shows that the memory that is held by the process that
creates the trap increases, and eventually causes a MALLOC failure. When this situation occurs, you
must reload the platform.
Conditions: This symptom is platform-independent and occurs in a configuration in which at least
one VRF destination has the snmp-server host command enabled.
Workaround: Ensure that no VRF is associated with the snmp-server host command.
CSCeh90984
Symptoms: When you enter the clear cef linecard command, CEF may be disabled on a POS ISE
line card and does not recover by itself.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(28)S3.
Workaround: Reload the line card.
Vista de página 415
1 2 ... 411 412 413 414 415 416 417 418 419 420 421 ... 677 678

Comentários a estes Manuais

Sem comentários