Cisco OL-4015-08 Manual do Utilizador Página 353

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 678
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 352
705
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
Conditions: This symptom is observed when you first power down the switch or router, install the
PA-MC-STM-1SMI, and then boot up the switch or router.
Workaround: Install the PA-MC-STM-1SMI via an OIR procedure.
CSCsa75375
Symptoms: You cannot configure the speed command on Ethernet interfaces.
Conditions: This symptom is observed on a Cisco 10720.
Workaround: There is no workaround.
CSCsa77105
Symptoms: An LSP ping (or traceroute packet) is incorrectly sent from an unlabeled interface,
preventing the LSP ping to detect LSP breakages when a one-hop label switched path is pinged.
Conditions: This symptom is observed on a Cisco router that is configured for MPLS OAM.
Workaround: There is no workaround.
CSCsa77411
Symptoms: A crash that is related to MPLS TE bandwidth management may occur on a Cisco router
which is configured for OSPF and MPLS Traffic Engineering.
Conditions: This symptom is observed on a Cisco router that integrates the fix for caveat
CSCef16096 when the following conditions are present:
The router is configured for OSPF and MPLS traffic engineering (TE).
The interfaces, OSPF adjacencies, and TE tunnels are flapping.
There are more than 300 OSPF interfaces (in any state, including administratively down) in the
OSPF area that is configured for MPLS TE.
You can check the number of interfaces by entering the show ip ospf or show ip ospf interface brief
command. Note that all interfaces that are covered by network statements are included in the
command output, even those that are in the administratively down state.
A list of the affected releases can be found at
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCef16096. Cisco IOS
software releases that are not listed in the “First Fixed-in Version” field at this location are not
affected.
Workaround: There is no workaround.
CSCsa80661
Symptoms: The data path on a 3-port Gigabit Ethernet Engine 2 (3GE-GBIC-SC) line card may be
reset because of a corrupted packet that is found in the Tx SOP SRAM. This situation causes packet
loss and the routing protocol sessions to flap.
Conditions: This symptom is observed on a Cisco 12000 series that runs a Cisco IOS
software release that includes the fix for caveat CSCef06121. A list of the affected releases can be
found at http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCef06121. Cisco IOS
software releases that are listed in the “First Fixed-in Version” field at this location are affected.
Workaround: There is no workaround. The symptom causes a disruption of service, but service is
restored.
Further Problem Description: When the symptom occurs, the following messages are generated in
the log:
Vista de página 352
1 2 ... 348 349 350 351 352 353 354 355 356 357 358 ... 677 678

Comentários a estes Manuais

Sem comentários