Cisco IE 2000 Especificações descarregar pdf (Página 186)

11-24

System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches

OL-29255-03

Chapter 11 Configuring SPAN and RSPAN

Configuring SPAN and RSPAN

Specifying VLANs to Filter

Follow this procedure to configure the RSPAN source session to limit RSPAN source traffic to specific

VLANs.

BEFORE YOU BEGIN

Review the “Information About SPAN and RSPAN” section on page 11-1 and “Guidelines and

Limitations” section on page 11-8.

DETAILED STEPS

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

no monitor session {session_number |

all | local | remote}

Remove any existing SPAN configuration for the session.

For session_number, the range is 1 to 66.

Specify all to remove all SPAN sessions, local to remove all

local sessions, or remote to remove all remote SPAN

sessions.

Step 3

monitor session session_number

source interface interface-id

Specify the characteristics of the source port (monitored port)

and SPAN session.

For session_number, the range is 1 to 66.

For interface-id, specify the source port to monitor. The

interface specified must already be configured as a trunk port.

Step 4

monitor session session_number filter

vlan vlan-id [, | -]

Limit the SPAN source traffic to specific VLANs.

For session_number, enter the session number specified in

step 3.

For vlan-id, the range is 1 to 4094.

(Optional) Use a comma (,) to specify a series of VLANs or

use a hyphen (-) to specify a range of VLANs. Enter a space

before and after the comma; enter a space before and after the

hyphen.

Step 5

monitor session session_number

destination remote vlan vlan-id

Specify the RSPAN session and the destination remote VLAN

(RSPAN VLAN).

For session_number, enter the session number specified in

step 3.

For vlan-id, specify the RSPAN VLAN to carry the monitored

traffic to the destination port.

Step 6

end Return to privileged EXEC mode.

Step 7

show monitor [session

session_number]

show running-config

Verify the configuration.

Step 8

copy running-config startup-config (Optional) Save the configuration in the configuration file.

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 335 336

Comentários a estes Manuais

Sem comentários

Cisco IE 2000 Especificações Página 186

Comentários a estes Manuais

Manuais e produtos relacionados com Software Cisco IE 2000