Cisco IE 2000 Especificações descarregar pdf (Página 275)

17-17

System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches

Chapter 17 Configuring Ethernet OAM, CFM, and E-LMI

Configuring Ethernet CFM

Configuring SNMP Traps

BEFORE YOU BEGIN

Review the “Information About Ethernet CFM” section on page 17-2 and “Ethernet CFM Configuration

Guidelines” section on page 17-7.

DETAILED STEPS

Use the no form of each command to remove a configuration or to return to the default settings.

EXAMPLE

Switch(config)# snmp-server enable traps ethernet cfm cc mep-up mep-down config loop

cross-connect

Configuring Fault Alarms

You can configure Ethernet CFM fault alarms in either global configuration mode or Ethernet CFM

interface MEP mode. In case of conflict, the interface MEP mode configuration takes precedence.

BEFORE YOU BEGIN

Review the “Information About Ethernet CFM” section on page 17-2 and “Ethernet CFM Configuration

Guidelines” section on page 17-7.

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

snmp-server enable traps ethernet cfm cc

[mep-up] [mep-down] [config] [loop]

[cross-connect]

(Optional) Enable Ethernet CFM continuity check

traps.

Step 3

snmp-server enable traps ethernet cfm

crosscheck [mep-unknown] [mep-missing]

[service-up]

(Optional) Enable Ethernet CFM crosscheck traps.

Step 4

end Return to privileged EXEC mode.

Step 5

show running-config Verify your entries.

Step 6

copy running-config startup-config (Optional) Save your entries in the configuration

file.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 335 336

Sem comentários

Cisco IE 2000 Especificações Página 275