Cisco CX-FEIP-2TX= Installation and con?guration Manual do Utilizador descarregar pdf (Página 39)

HP OpenView NetMetrix/UX Release Notes version 6.0

October 1, 1998

Known Problems and Work-Arounds

38 October 1, 1998

Description Creating more than 60 echo tests on a probe results in an error

message

Symptom When you create more than 60 echo tests on a LanProbe, a message indi-

cating that “an error occurred when attempting to set the slow-response

RMON alarm for the target… Please try again.”

Details Most probes support up to 100 echo tests but have a maximum of 60

alarms. When you create a response test on a probe, IRM conﬁgures an

alarm that triggers when the response time is slow. If 60 alarms have

been conﬁgured (whether for echo tests or for other purposes), conﬁgur-

ing any additional echo tests will result in the error message.

[Defect ID 0804–009191]

Work-Around None. Note that any affected echo test targets will indicate available/

unavailable status correctly; this problem affects only the slow-response

status.

Description Setting the LanProbe test interval in IRM using the “Set to

Defaults” button has no effect

Details IRM’s Conﬁguration➤Distributed Network Analysis➤Set LanProbe Test

Interval menu item changes the echo test interval for a LanProbe. Push-

ing the “Set to Defaults” button in the resulting window has no effect.

[Defect ID 0804–009357]

Work-Around Instead of using the Set to Defaults button, change the seconds ﬁeld to

60, then press OK.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 50 51

Sem comentários

Cisco CX-FEIP-2TX= Installation and con?guration Manual do Utilizador Página 39