Cisco Octal-Port DMT ATU-C Line Card Manual do Utilizador Página 18

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 50
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 17
DSL Access Architectures and Protocols 193
Step 4
Configure the VPDN group to accept the dial-in and to be used to establish
PPPoE sessions. Also specify the virtual template that will be used to clone
virtual-access interfaces:
vpdn-group
number
accept-dialin
protocol pppoe
virtual-template
template-number
Step 5 Create the ATM subinterface and PVC. Also configure AAL5SNAP
encapsulation and specify the PPPoE protocol that the VPDN group will use:
interface atm
slot
/0.
subinterface-number
{multipoint | point-to-point}
pvc [
name
]
vpi/vci
encapsulation aal5snap
protocol pppoe
Step 6 Create the virtual template interface:
interface virtual-template
number
Step 7 Conserve IP addresses by configuring the ATM subinterface as unnumbered,
and assign the IP address of the interface type you want to leverage:
ip unnumbered
interface-name-number
Step 8 Configure the maximum transmission unit (MTU):
ip mtu 1492
Because Ethernet has a maximum payload size of 1500 bytes, the PPPoE
header is 6 bytes and the PPP ID is 2 bytes, so the PPP MTU must not be
greater than 1492 bytes.
Step 9 Create a local IP address pool:
ip local pool
name begin-ip-address-range
[
end-ip-address-range
]
Step 10 Specify the IP address pool for the interface to use:
peer default ip address pool
poolname
Step 11 Enable CHAP or PAP authentication on the interface:
ppp authentication {chap | pap | chap pap | pap chap} [if-needed]
{default |
list-name
} [callin]
Example 8-12 demonstrates the PPPoE configuration of the Cisco 6400 NRP.
Example 8-12 PPPoE Configuration
username cisco password 0 cisco
!
vpdn enable
!
vpdn-group 1
continues
0732x01.book Page 193 Monday, November 17, 2003 2:49 PM
Vista de página 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Comentários a estes Manuais

Sem comentários