
Summary 223
dmt interleaving-delay downstream
delay-in-
µ
secs upstream delay-in-
µ
secs
Sets the interleaving delay parameter.
dmt training-mode {standard | quick} Sets the training mode in a DMT profile.
bridge irb Enables IRB.
bridge bridge-group protocol {ieee | dec} Specifies the bridge protocol to define the type
of Spanning Tree Protocol.
bridge bridge-group route protocol Specifies a protocol to be routed in a bridge group.
bridge-group bridge-group Assigns a network interface to a bridge group.
interface bvi bridge-group Enables a bridge group virtual interface.
atm route-bridged ip RBE command. Typically used to associate with
an interface.
username name password secret Configures a username and password for local
authentication.
encapsulation aal5mux ppp Virtual-
Template number
Configures PPPoA encapsulation and associates
a virtual template with it.
interface virtual-template number Creates a virtual template interface.
ip unnumbered interface-name-number Conserves IP addresses by configuring the
interface as unnumbered, and assigns the IP
address of the interface type you want to leverage.
ip local pool name begin-ip-address-range
[end-ip-address-range]
Creates the local IP address pool.
peer default ip address pool poolname Specifies the pool for the interface to use.
ppp authentication {chap | pap | chap pap |
pap chap} [if-needed] {default | list-name}
[callin]
Enables CHAP or PAP authentication on the
interface.
ip cef Enables Cisco Express Forwarding switching.
vpdn enable Enables VPDN configuration.
vpdn-group number
accept-dialin
protocol pppoe
virtual-template template-number
Configures a VPDN group to accept the dial-in
and to be used to establish PPPoE sessions.
Specifies the virtual template that will be used to
clone virtual-access interfaces.
ip mtu bytes Sets the MTU size of IP packets sent on an
interface.
show dsl profile Displays the DSL profile you changed.
continues
Table 8-3 Summary of Commands Used in This Chapter (Continued)
Command Description
0732x01.book Page 223 Monday, November 17, 2003 2:49 PM
Comentários a estes Manuais