Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica descarregar pdf (Página 104)

642-531

Answer:

Explanation:

password: Certkiller 1636

sensor#

1.sensor# copy current-config ftp://adm[email protected]/ Certkiller 5287/backup-cfg

password: password2

2. sensor# show user all

3. sensor# config terminal

sensor(config)#no username service (service is the username for service account)

4.sensor(config)# privilege user tessking operator

5. sensor(config)#service virtual-sensor-configuration virtualSensor

6. sensor(config-vsc)#reset-signatures service-http all

Reference for Reset Signatures

http://www.cisco.com/en/US/products/sw/secursw/ps2113/products_command_reference_chapter09186a00801

471c9.ht

QUESTION 242

You are a network security at Certkiller Inc. Certkiller is installing new Cisco IDS Sensors. You have to

configure the new Sensors to permit remote access from trusted hosts exclusively. Perform this task on

one of the Sensors using the command line interface (CLI). Refer to the following information and

network topology graphic to permit access from the IDS MC management station only to the Sensor.

Due to this being a new installation, you must remove the default allowed network address. Note: Verify

your configuration setting prior to saving, and then save your configuration when finished.

Cisco IDS Parameters Settings

Sensor operator username/password operator/ Certkiller 1636

Sensor administrator username/password admin/ Certkiller 1636

Sensor IP address: 10.10.10.200/24

Default allowed network address: 10.0.0.0/8

Click on the picture of the host connected to an IDS Sensor by a serial console cable.

Answer:

Explanation:

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 122 123

Sem comentários

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica Página 104