Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica descarregar pdf (Página 96)

642-531

a NAT device

B. Informs the IDS device which address to use in order to send alarms to Monitoring Center for Security when

separated by a NAT device

C. Specifies to Monitoring Center for Security the true address of an IDS device located behind a NAT device

D. Identifies the IP address of a NAT device that separates Monitoring Center for Security from the IDS device

E. Informs the IDS device which address to use when sending TCP resets to offending traffic when a NAT

device separates the IDS device from Internet traffic

Answer: A

IDS MC uses the NAT or Pubic IP address to connect to the Sensor which uses the Private key in case where

the Sensor

is using the NAT.

CiscoPress CSIDS Self-Study Second Edition Earl Carter, Page 287

QUESTION 224

What does a value of zero (0) in the parameter field "maximum number of bytes in a log event" imply when you

are configuring IP logging using IDS MC?

A. Disabled the automatic logging feature.

B. No packets will be logged.

C. No limit of packets logged.

D. Zero is an invalid setting.

Answer: C

Explanation:

Page 420 Cisco Press CCSP 2nd Edition under IP Logging parameters in IDS MC

See Screenshot diagram, it is stated 'Maximum number of packets in a log event (0 implies no limit)

Cisco Courseware 12-20

QUESTION 225

Which protocol does theMonitoring Center for Security use to monitor alarms on a Cisco IOS router?

A. SSL

B. SSH

C. RDEP

D. Syslog

E. Not supported

Answer: D

QUESTION 226

Which of the following represents aprotocol used by the Monitoring Center for Security to monitor alarms on a

PIX Firewall?

A. SSL

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 122 123

Sem comentários

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica Página 96