
642-531
Explanation:
We must agree with the conclusion that this is nonsense, but E must be the correct answer since a hub a layer 2
device meaning that it doesn't do network segmenting. All devices connected to the hub wil receive the same
traffic.
QUESTION 47
Study the exhibit below carefully:
According to the exhibit all switches are connected through Fast Ethernet connections. Server Certkiller 3 is in
VLAN 8. The Catalyst 4000 is running Catalyst OS. Which of the following commands represents a valid
configuration step to permit IDS3 to monitor traffic sent to and from Server Certkiller 3?
A. 4000(config)# monitor session 1 source vlan 8 both
B. 4000(config)# monitor session 1 destination interface fastEthernet 3/24
C. 4000>(enable) set span 3/5 3/24 both create
D. 4000(config)# monitor session 1 source fastEthernet 3/5 destination fastEthernet 3/24 tx rx
E. 4000(config-if)# port monitor interface fastEthernet 3/5
F. This feature is not supported in this configuration
Answer: C
Cisco Courseware 5-18
QUESTION 48
Identify two basic steps in the configuration of VACLs for traffic capture on a Catalyst 6500 switch
running IOS. (Choose two.)
A. Configure match clauses using the capture option.
B. Map the VLAN access map to a VLAN.
C. Use commit to save the VACL configuration.
D. Assign ports to receive capture traffic.
E. Crate VACL using the set security acl command.
Answer: B, D
Explanation:
The tasks to capture traffic using VLAN Access Control Lists (VACLs) on a Catalyst 6500 switch running IOS
are as follows:
1) Configure ACLs to define interesting traffic.
2) Define a VLAN access map
3) Configure the match clause in the VLAN access map using ACLs
4) Configure the action clause in the VLAN access map using the capture option.
Comentários a estes Manuais